I just need some one to throw some input and let me know if my gap sizes are alright before i do them. I searched and came out to this for a conculsion.
1st ring. .019
2nd ring. .021
Oil ring. .023
Its a z6 block bored .40 over(yes i know its big but what i had to work with) had the p2w set to .003. They are vitara pistons. I am shooting for 350whp. Do the gaps seem alright or should i make them a bit bigger or smaller.
I want to know quick so i can finish plastigauging the bearings tonight and put the pistons in. thanks for the input.
1st ring. .019
2nd ring. .021
Oil ring. .023
Its a z6 block bored .40 over(yes i know its big but what i had to work with) had the p2w set to .003. They are vitara pistons. I am shooting for 350whp. Do the gaps seem alright or should i make them a bit bigger or smaller.
I want to know quick so i can finish plastigauging the bearings tonight and put the pistons in. thanks for the input.