Joined
·
3 Posts
i have a d16z6 engine block and crank can i use all the d16y8 bearing in it
z6 block y8 bearing
1 - 4 of 4 Posts
Joined
·
52 Posts
yes same crank and bearings... just two different pulley snouts
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Srt4 head bolts in d16a6/y8
Engine BuildingIt’s been awhile, I’ve been build mostly dsm based cars for the past 7 years but I started with Honda. I recently picked up a 97 dx and I’ve decided to build a motor for a fun little beater. I’m planning on using a d16a6 block with a y8 head. I time certed the block to use srt 4 studs , m11x1.5...- 1
- 53
-
Best resource for build information
Engine BuildingI'm starting an build and am looking for a good source for info about choosing piston to wall clearance and ring end gap when adding boost and when going NA. Is there a link or a book that I should be looking at here?- 7
- 166
-
Henry44 · updated
-
D16y8 build help
Engine BuildingSo im currently building a d series for turbo, hopefully i can push anywhere around 450-500. I had some friend told me if i was going for that much i would have to also replace my crank cap bolts (or whatever they are called, included a picture down below) He said i should upgrade for better...- 5
- 182
-
1998 EJ6 Mini-Me build Y8 or D6 Head!?!?
Engine BuildingSince high school I’ve always wanted a little Honda since most my friends had 90s era Hondas growing up. I’ve driven quite a few from ef with sohc vtec to a GSR dohc vtec. I had some extra cash and decided I wanted a little project car and found something for a great price. I picked up a 98...- 5
- 150
-
BlkLytEj6 · updated
-
95 civic d16z6 oil pressure
Engine BuildingHi, I just put together my turbo d16z6 build and did my first start. The engine cranks right up and idles just over 1000 rpms cold. Sounds healthy too. The oil light goes out when the engine is started. Just want to know if I will get an oil light if the oil pressure is too high? Reason being is...- 4
- 269
-
sirusdpx · updated
Join now to ask and comment!