Honda D Series Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
Spun a rod bearing in my D16A6, and I'm electing to just replace it. Crank must be in good shape, and not spun a bearing or anything. Same goes with the rod.

If you want to get rid of all your rods, or even a whole block for cheap, let me know.

I'm in North Texas btw. If you're any farther than Dallas or OKC, it's gonna have to be shipped.

Thanks :TU:
 

·
Brokedick Millionaire
Joined
·
40,968 Posts
I should have a set of 4 D16 OEM rods coming back from the machine shop this week.......

Where are you located?????

Cheap + shipping.....
 

·
Formally known as SPONSOREDCRX
Joined
·
3,566 Posts

·
Registered
Joined
·
725 Posts
I have 8 a6 rods, only two had a spun bearing(both in the same motor). Make me an offer on them all. I need them gone. Pistons are still on them as well. LMK
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top