hey,tried searching came up empty handed,working on the car right now so figured i'd try posting.anyway,my 94 hatch d15 non vtec won't rev if you give it a quick shot of gas.just did a head gasket and timing belt.i put the timeing light on everything looks good,if you ease the throttle on its ok,but if you give it a shot it bogs..any suggestions?thanks
Won't rev ('94 D15)
1 - 4 of 4 Posts
clogged fuel filter/ injectors?
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Vitaras in a b7! so many questions ZERO answers
General TechFor you say anything I've done the search of done four searches and after getting to the 20th page I give up . My plan is to use a D15B7 and put the Max peating rod rods which are higher at 134.5 mm which is only at half a millimeter larger than stock rods. Along with this I plan for a z6 head...- 21
- 188
-
Delta Cams 260 "Torque Grind" and 272...
General TechHas anyone here actually used the Delta 260 "torque grind" or known someone who has? I'm curious about it's performance for a daily driver... Also, has anyone used the 272 and played with the cam timing? What was the best setting for your build? Any other info would be appreciated as well...- 2
- 86
-
Nasty_Canasta · updated
-
1997 Honda Civic Hatchback D16Y7 turbo with a TD04 turbo?
General TechHello, I am new to this site, I have been trying to get some help from other sites for about 2 weeks now and haven't gotten a single reply yet, hopefully this site will be quicker and better suited for my needs. I have a 97 hatchback with a rebuilt d16y7, and the acura 5spd transmission. I...- 9
- 176
-
Doritoboy100 · updated
-
D16y8 ticking noise need help
General TechFirst, I have a full d16y8 except intake is a z6. It was recently built by me i have only started it maybe 4 times to do heat cycles and to tune the idle it has not been driven. Parts- stock head, p2p0 rods, vitara pistons, acl race bearings, arp head studs, turbo, skunk2 catback exhaust...- 11
- 342
Join now to ask and comment!