Honda D Series Forum banner
1 - 3 of 3 Posts

·
Banned
Joined
·
283 Posts
Discussion Starter · #3 ·
:hammer: I know but that wasn't my question...

I guess I can burn the chip again without o2 sensor to test it... but I was looking for a good answer...

does the orientation of the resistor or capacitors matter?

what sensors cause limp mode? Its probly a bad solder point but they are shinier than :mikej:

it runs fine with j1 off so that means its not a sensor right? or does it check o2 with the j1 on? thats my question
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top