Honda D Series Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
Ok, here in Japan, at least in my experience, nobody really cares whether a wheel is 1, 2 or 3 pieced. But people in the US seemed to be all for the 3 pieced wheels?

Can somebody explain it to me? I am missing out any American top secret?
 

·
Tape-R taper/driver
EC3, ED8, ED9, EE5
Joined
·
574 Posts
It's fancy and it is easier to dial in the offset while keeping the same center piece.
 

·
BATSLOMAN GIVES NO FUCKS.
Joined
·
5,033 Posts
whats it cost for an r34 over there, since we share our secrets ;)
 

·
Asshole
Joined
·
4,112 Posts
If you bend or curb a wheel really bad you have to replace the whole wheel with 1 and welded 2 piece wheels. With a 3 piece wheel, you only replace the outer barrel in most cases. I would like a set of used wheels for cheap please.
 

·
Registered
Joined
·
50 Posts
Discussion Starter · #7 ·
whats it cost for an r34 over there, since we share our secrets ;)
Do you mean the whole R-34? Skyline?

If it's a good GT-R, somewhere around 4 to 8 million yen (35 ~ 70 thousand USD)

A normal version Skyline can be found for half or even one third of that.
 
1 - 8 of 8 Posts
Top