Honda D Series Forum banner

Wastegate fitment...

892 Views 9 Replies 7 Participants Last post by  kyle h.
i've been meaning to upgrade my turbonetics delta mark II wastegate for a while. I think it's a leaker! It seems to be throwing exhaust at the valve cover, because after about a week or so the front of the valve cover has black shit on it.

what i was wondering was, is there a wastegate that is gonna fit like the delta mark II? i didn't want to make a huge modification to my setup, so i just need to find something to clear the hood. i know the tial isn'y gonna work...:(

any idea's???

here's my setup for those of you who don't know...

See less See more
1 - 10 of 10 Posts
you cud make an elbow.. then the tial would fit
you cud make an elbow.. then the tial would fit
i could, but i didn't really want to have to modify anything like i said above.


Cut this elbow off, buy 2 flanges and some gaskets. Weld the flanges onto the elbow and bam. Done.
See less See more


Cut this elbow off, buy 2 flanges and some gaskets. Weld the flanges onto the elbow and bam. Done.
yea, me and my buddy were talking about this today and i'm gonna have to go that route. tunertoys had some flanges with some nice bends for a little over $20. my buddy just got a welder for xmas, so i think were're going to have to do some expierimentation! hehe
Deltagates share the same flange as Tials and knockoff Tials
Deltagates share the same flange as Tials and knockoff Tials
w3rd it should be a direct swap. the china ones are taller than the real tia. keep that in mind
w3rd it should be a direct swap. the china ones are taller than the real tia. keep that in mind
cool. thanks
check the turbosmart ones out too. I believe they have the same flanges and are pretty low profile.
are you sure it wont clear the hood?
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top