Honda D Series Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1 (Edited)
Not sure where this should be but I'm getting a code p1259.
I have hard wired my solenoid and Rewired my oil pressure switch And it was working fine until this past week.
I'm getting the code coming back as soon as I erase them with key on engine off so I'm lead to believe it's a wiring issue but my question is does anyone know the honda procedure to test both the solenoid and switch to rule the actual hard part out and then I can move to re-wiring with new pig tails etc.?
 
1 - 1 of 1 Posts
Top