Honda D Series Forum banner
1 - 5 of 5 Posts

·
Registered
89 CRX si
Joined
·
71 Posts
Discussion Starter · #1 ·
I'm tearing down my D16A6 and I have been reading posts and watching youtube video's on how to go about the removal of the valve springs on a D series head. I have yet to see a good tool for this job that is relatively sane and without the possibility of losing the keepers. I have found an OTC 4572 that looks like it might work and I would like to know if anyone here uses the OTC or knows of a great way of compressing the springs for removal of the keepers and will allow the installation to be without incident.
 

·
Registered
Sloppy Jalopy
Joined
·
2,007 Posts
should do the job but will be a pain in the ass to get to the keepers if you have short stubby fingers.


I see you only have one eye so make sure whatever tool you do chose always wear safety googles while using .
 

·
Registered
89 CRX si
Joined
·
71 Posts
Discussion Starter · #4 ·
The tool looks to me that its has plenty of open space for use of a magnet to pull those keepers out.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top