Honda D Series Forum banner

1 - 18 of 18 Posts

·
Registered
Joined
·
1,217 Posts
Discussion Starter #1
ok so i loosened the nut holding the compressor wheel on, and the compressor wheel will not come off the shaft... how am i supposed to get this thing apart lol...
 

·
Registered
Joined
·
1,217 Posts
Discussion Starter #6
umm how do i pry the wheel off. i got no idea what i can use cause i sprayed pb blaster at the top and let it sit over night and nothing happend lol.
 

·
Registered
Joined
·
1,217 Posts
Discussion Starter #9
i didnt see a snap ring when taking it off... only snap ring i saw was on the waste gate rod.
 

·
Registered
Joined
·
1,217 Posts
Discussion Starter #10
EG6-Jarhead said:
$236 so far from relatives :TU:

great congrats...

now back to my thread... lol i managed to get the cold side wheel out by turning the turbo around and lightly tapping the shaft to the ground lol... also ended up breaking snap rings when i tried to remove one... so do all t3 turbo rebuild kits the same?

thanks
 

·
Registered
Joined
·
1,217 Posts
Discussion Starter #15
oh ok. thanks. now are snap ring plyers expencive to buy and could get them at like AZ or pepboys?
 

·
Registered
Joined
·
1,217 Posts
Discussion Starter #18
i should look into this lol... i want to buy my rebuild kit but i dunno where. i see on ebay too but who knows lol...
 
1 - 18 of 18 Posts
Top