The engine is a d16z6, ecu is a p28, car is an 89 dx. I used a premade obd conversion harness and did the mpfi/distributor wiring myself.
Whats happening now is the car will not start, it cranks but has no spark, and the check engine light , along with the oil light, just stays on when the key is turned to "on". i have replaced the main relay, and i know its not the igniter or ignition switch.
I'v run out of things to check and have done extensive searching here and all over the internet.
Someone please just point me in the right direction, what can i check next?
Thanks,
Shane
Whats happening now is the car will not start, it cranks but has no spark, and the check engine light , along with the oil light, just stays on when the key is turned to "on". i have replaced the main relay, and i know its not the igniter or ignition switch.
I'v run out of things to check and have done extensive searching here and all over the internet.
Someone please just point me in the right direction, what can i check next?
Thanks,
Shane
