[TheAssassin]

Dont know till you run it.
I have no idea what power that setup will net. So its hard to say if it will hold up.
How about dyno it and stop the pis when you get to around 225whp. Then your be good.

Listen to this. Set a horsepower goal as opposed to a pressure goal. There are too many variables that affect the amount of power made on a certain psi.

 

[TheAssassin]

My previous set up in my build thread produced 211whp/168wtq on the stock block and lasted perfectly before I swapped it out for my built engine.

 

[TheAssassin]

Yes it is all in my build thread, and thank you for the reference. It is a Garrett T3 60 trim .48 ar. I made 211/168 on 7 psi and 278/224 on 15psi. PM me or start a thread if/when you run into trouble, I'll be happy to help.