Honda D Series Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
0 Posts
Discussion Starter · #1 ·
So, got my block torn down finally (d16y7) and was ready to pull the trigger on P2P0 rod set but as most you know they are back ordered.

Some digging around and the skunk2 popped up on the search. Same length and not much more then P2P0, they are H beam versus I but I don't see that as an issue since my HP goals are no where near what it claims it is rated for.

I know some don't like this brand but has anyone actually ran these? Should I wait on P2P0 rods, will they make more? not sure what to do and I want to keep this build going.

thanks
 

·
Classic Man
Civic
Joined
·
16,355 Posts
The skunk2 rods should be very comparable to other "chinese rods", which means they work good.
 

·
Registered
95 civic ex
Joined
·
0 Posts
Sorry I'm a little late on this but I run the d16z6 version of the Skunk2 rods and vitara's. 12k on the build and still no issues. Clearances were good. 350hp its not alot of power.
 
1 - 5 of 5 Posts
Top