Honda D Series Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
962 Posts
Discussion Starter #1
k guys i bought a set of used manley turbo tuff rods for 4g63 from ebay. upon arrival i found 2 of the rods have been machined on the big end bore apparently due to spun bearing.

i send the rods off for measurement. the big end bore come out to be perfectly round and equally sized. problem is 2 of the rods length c to c is shorter by 0.5mm due to cap and rod being machined off for rebore.

can this rod be used? i bought them cheap anyway and hate to return it to the usa as i will be paying a expensive shipping.
 

·
Registered
Joined
·
3,314 Posts
.5mm is such a small difference, I don't see it being a big deal. The shop should of resized them all thou.
 
1 - 5 of 5 Posts
Top