Honda D Series Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
Ok guys, I got a header for my D16Z6 off some kid on Craig list for $20. It fits great and works fine. However, someone else is offering to trade a Kamikaze Header from a 96-00 LX Civic for a stocker straight across. So Im thinking, get a a Kamikaze Header for $20 (my original cost) !!!!!! However, I just want to ensure they will fit. I was under the impression that ALL D series headers were compatible..... but let me know

Thanks!
 

·
my name says Guest, but Im really a MEMBER
Joined
·
10,488 Posts
there all the same except that you have to use a z6 pan to use the z6 header on an EF.
 

·
Banned
Joined
·
3,566 Posts
If it is a 4-1 Kamikaze I would not trade it at all. It has a flat spot on the dyno just at the start of topend and you can actually feel it when driving at WOT. I did alot of the designing for HOTSHOT Performance for many years and they copied our 4-1 Civic design. But we changed it right after the dyno test. The runners are not long enough and then it basically gets crammed into the small collector. Not a very good design.
Don
 

·
Banned
Joined
·
3,566 Posts
Bisimoto is the ONLY way
 
1 - 10 of 10 Posts
Top