Honda D Series Forum banner

Status
Not open for further replies.
1 - 20 of 39 Posts

·
Registered
Joined
·
575 Posts
Discussion Starter #1 (Edited)
Rcautoworks now offers cylinder head porting services so to benchmark this momentous occasion we want to pass on some savings to you good folks. PM me for the details on where to send heads and payment information. Only 10 spots available.

Payment options are the following send the head in whenever work will be started once half of the money has been sent and the other half can be sent after the work is complete.

This will go very well with our built blocks as well. Get everything done right so all you have to do is slap it in the car.

The stage 3 with a oem valve job and milling for $600 shipped

Features,

Disassembly
Fully cleaned
soda blasted
fully Ported intake/ported-polished exhaust
New OEM valve seals
Re cleaned
Reassembled
spec'd out

full oem 3 angle valve job
milled up to .020 flat
shipped to the lower 48 states


The stage 2 with a oem valve job and milling for $450 shipped

Features,

Disassembly
Fully cleaned
soda blasted
Ported/gasket matched intake side
New OEM valve seals
Re cleaned
Reassembled
spec'd out

full oem 3 angle valve job
milled up to .020 flat
shipped to the lower 48 states


This group buy ends 7/4/11
 

·
Registered
'97 crv
Joined
·
1,467 Posts
FRizeking bump! If only I had an extra head around.....
 

·
Registered
My civic
Joined
·
2,340 Posts
I have extra head laying around.... no Cam... have springs.. retainers.... valves....cam caps.... rocker arms not very great. But if you need it to send for p&p it will work. Just swap your current assembly over and bam!! Not trying to thread jack, just trying to help out fellow DSO's and RC! PM w/ offer if someone wants it.
 

·
Banned
Joined
·
1,234 Posts
Does this come with a before and after flow chart? CNCed heads, or just hand ported and eyeballed?
 

·
Premium Member
Joined
·
5,819 Posts

·
Banned
Joined
·
1,234 Posts
Show me CNC'd heads for this cheap they are hand ported and damn good......Dude you come in most of these threads put up by Rc and have some shit to say.......
Yea, I didnt think they would be CNC. It was just a question. You dont need to get all sad and offended... I didnt know who was doing the work...

Bump for good port work.
 

·
Registered
Joined
·
575 Posts
Discussion Starter #13
Just trust us when we say this guy is a heavy weight in the game. If you want the head flowed that will be extra give me a minute and Ill put up some pictures of the work he has done for some others. Including 2 of the shop cars



 
1 - 20 of 39 Posts
Status
Not open for further replies.
Top