Honda D Series Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1
I have a D14a1 that i'm building with a y8 head.

My question is: is it safe to make a 0mm piston to deck clearance with the y8 head (using standart 3 layer y8 gasket) and pm7 pistons?

I'm not asking about valve clearance, but piston to chamber contact problems. The dome is very wide, and chamber is, errr, square. Will it be ok?
 
1 - 1 of 1 Posts
Top