Honda D Series Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
this is a question i looked for and couldnt find and answer to. i have a set of p29's and a wicked ported y7 i wana put in i dont want the compression too crazy so can i mill the p29's dome so it isnt so high and doesnt knock my valves back to the 80's. and would this have any effects to the piston like im talking .1 mill off the top.
 

·
Registered
see above
Joined
·
4,258 Posts
milling the pistons?. i dont think so. what block is the going into? y7/z6 d15b shows 12.07:1 with piston to deck 0.039
 

·
Registered
Joined
·
19 Posts
Discussion Starter #5
thank you guys for the answers mill the pistons i shall worst case scenario i blow the motor up and i have to get a new one could be worse. and it is going in a y7 block.
 
1 - 5 of 5 Posts
Top