Honda D Series Forum banner

1 - 3 of 3 Posts

·
Curious George
'99 LX Civic Sedan
Joined
·
3,569 Posts
Discussion Starter #1
I have noticed on D16a6 head and pistons that exhaust valves haven't the same location than z6/y7/y8. Pm6 pistons under these heads won't fit with high lift cam due to valve reliefs location.

Somebody has more information about other pistons who may have different location for valve reliefs ? I'm looking for higher domed pistons (at least flat top)into d16Y series with more than .400 lift., around 11:1, I can play little bit with different head gasket.
 

·
Curious George
'99 LX Civic Sedan
Joined
·
3,569 Posts
Discussion Starter #3
They're not more than 12:1 CR ? so many stories about GX slugs.

Sounds good, already have LS rods machined for them :)

some nitrous shot after and go race :)
 
1 - 3 of 3 Posts
Top