Honda D Series Forum banner

piston question

805 Views 6 Replies 3 Participants Last post by  HONDATUNER356
does anyone know if pm7 or p29 pistons will fit in a b7 or b2 block without having to over bore. if so, which rods would i use. just looking for some ways to up the compression. im thinking of a new build with oem parts that i can get cheap from someone or at a junk yard. lmk



thanks
Adam
1 - 7 of 7 Posts
"should" kiss the spark plug too!!!!!

Save your money and get a D16 motor.
so if get a d16a6 block would they be alright in there with by b7 head. i would like to stay with the sohc non-vtec. if that does work, whick rods do i use then.
so if get a d16a6 block would they be alright in there with by b7 head. i would like to stay with the sohc non-vtec. if that does work, whick rods do i use then.

use the stock d16 rods.
"should" kiss the spark plug too!!!!!

Save your money and get a D16 motor.

thanks for correcting, "should" was the key word when i was posting.
use the stock d16 rods.

do you mean the d16a1 rods that are on the pm7's or the ones in the d16a6 block or are they the same length and stroke. sorry for all the questions just want to make sure.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top