Honda D Series Forum banner
1 - 4 of 4 Posts

· Registered
same as above
Joined
·
1,215 Posts
Discussion Starter · #1 ·
Im finally gonna switch over the other hatch to obd1.Currently as you know its obd0 .I dont feel like wasting the money on the harness and would like to make one on my own or just solder obd1 plugs on my harness but i need a list or color and identification of the wires running to the ecu.Can anybody help me?
 
  • Like
Reactions: BLACK-KNIGHT

· Registered
Joined
·
3,722 Posts
http://hondatech.info and download both the EF and EG manual. Then just swap and solder 1 wire at a time. Make sure you heat shrink them also.
 

· Registered
Joined
·
249 Posts
that or you ca do what i did in the past and desolder a OBD-0 Ecu for the plug then get some harness clips from a OBD-1 car and make your own jumper harness, but ive done it both ways so good luck...
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top