Honda D Series Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1 (Edited)
i didnt know that i was suppose to notch block so my block is bored to 75.5 and honed.. can i notch it anyway ?``
and how deep i dont want to mess it up
 

·
Registered
Joined
·
42 Posts
Discussion Starter #5
i need do notch .. the beams are hittinng the cylinder walls... i only want to know if i need to hone it again after i notch it..
 

·
Registered
Joined
·
42 Posts
Discussion Starter #12
if i get it right its suppose to be a straight angel betwen the 2 marks you make ?? and rounds of the ends.. right ?? 1/4 down in cylinderwall and 1/4" in to block ?? im soo scared to F%¤ck this up :D i spend 550 $ on boring the block.. any oilchannels thats hiding ..
 

·
Registered
Joined
·
98 Posts
Dont be scarred. The main thing is to make sure all your shavings are out of the block completely. You dont have to take off too much. All the oil galleys are out of the way.
 
1 - 13 of 13 Posts
Top