Honda D Series Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
430 Posts
Discussion Starter #1
ok guys ive finally decided to go to a d16y block ive got eagle esp rods and srp forged 9.1:1 pistons.
i plan to get my engine tuned with my hondata

but my question is how much whp can i expect this engine to handle still having stock sleeves and crank?

what is the max boost you think that this setup could handle is?
 
O

·
Guest
Joined
·
0 Posts
stock crank will take well over 700 hp so not a issue there. stock block can be tuned to 16psi "safley" 17 is pushing the limits and 18 is well your taking a BIG risk.

16 psi with a properly tuned car shoudl get you around 285-300 wheel power
 

·
Registered
Joined
·
430 Posts
Discussion Starter #4
oscarmayer said:
stock crank will take well over 700 hp so not a issue there. stock block can be tuned to 16psi "safley" 17 is pushing the limits and 18 is well your taking a BIG risk.

16 psi with a properly tuned car shoudl get you around 285-300 wheel power
oscar. what about the compression my pistons showed up yesterday and they are like10.2-5:1 would these still be alright?? i would just have alot better low end torque and quicker spool right?? cause its gonna be a pain to send them back
 
1 - 4 of 4 Posts
Top