Honda D Series Forum banner

1 - 2 of 2 Posts

·
Registered
1990 ef Hatch
Joined
·
270 Posts
Discussion Starter #1
So i have a d16z6, I did the head a few months back. Skunk2 valves, springs, and retainers. port and polish plus a three angle valve job. I'm building the block now. bored .040" over 76mm vitara pistons with eagle H-beam rods. I was wondering which direction the rods should face. eagle to the front or back? also does anyone have a trick to installing the wrist pin clips?
 

·
Lifetime Awesome Member
'89 CRX HF
Joined
·
25,544 Posts
Bearing tangs towards exhaust side

PS, this is not the classifieds. I've already closed or moved threads where you are looking to buy outside the Classifieds. Please stop if you want to remain a member of this site.
 
1 - 2 of 2 Posts
Top