Honda D Series Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Ok im coming to all you d-series gurus for help getting started. Im just beginning to get started and so far here is what i have. D16Y8 head w/ 63k miles and a y8 mani. Here is what i want : cams (having a tough choice here...bisimoto 2.4 or crower stage 2??), supertech Ti valve springs and retainers, supertech valves, supertech vavle guides, full port and polish on both the head and the mani, 5 angle valve job on top. on bottom i want either a y8 or z6 block (which do you think is better??), the block sleeved (best sleeve?) and bored out (what is better, .020 or .040?), eagle h-beam rods, wiseco or SP forged pistons, ARP headstuds, crank turned, micropolished, and blueprinted, ported oil pump. Later down the road i WILL tubo this but first i want to get the build finished. if anyone has any good tips, that will be highly appriciated!!!!

FYI i will be posting pics as i go cuz everyone like the pics lol
 
1 - 3 of 3 Posts
Top