Honda D Series Forum banner
1 - 4 of 9 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
im getting ready to start buliding my d16y8 and was hoping someone could give me suggestions and about how much power i should be able to hit

wiseco pistons eagle rods 1000cc injectors walbro255 hondata s300 50trim turbo arp studs cosmetic hg aem water methanol staged cluch 8lbflywheel

block bore 20 to 40 over what kinda hp should i be able to hit and what psi
1 - 4 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.