Honda D Series Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
676 Posts
Discussion Starter #1
ok people. I just want to know how would I be able to find out how much my head got milled. I´m trying to get to 0.80. But when I went to the machine shop to get it done. But the owner of the shop was discuraged of doing it. So I´m thinking he only took off a little. How would I go on measuring to know how much it´s been milled???
 

·
Brokedick Millionaire
Joined
·
40,226 Posts
You can go more than .8mm, what head did you shave????

I've seen .080" and recently a .100" Z6 head.

but those are extremes
 

·
D-series Janitor
Joined
·
1,220 Posts
a friend of mine milled a a6 head .080 and had issues with the head gaskets on nitrous.

So you would probably be pretty close with anything more even if it is n/a
 

·
Registered
Joined
·
857 Posts
My PM3 D15 head is also milled .1" ATM, and you guys both have seen it 8)
Waiting new valves and guides before that head gets ground by one another .01" :)
 
1 - 14 of 14 Posts
Top