Honda D Series Forum banner

1 - 9 of 9 Posts

·
Registered
91 CRX Si
Joined
·
4,454 Posts
no need to notch
 

·
Registered
ex-g (canadian)
Joined
·
624 Posts
only thing i know... you must shave a little bit on each side of the rod... then you need to make a bushing for the wristpin... and i'm kinda stuck on this part
 

·
Registered
Joined
·
4,732 Posts
for $225 shipped to ya house u can have brand new H beam rods good for 650hp. notching is easy as a mutha fucka, I even have a site with 123 directions on how to. its just a 1/4inch x 1/4inch notch. easy shit
 

·
Registered
Joined
·
1,170 Posts
i dont think shaving any part of ur rods is safe u just making them weaker
 

·
Registered
ex-g (canadian)
Joined
·
624 Posts
b serie rod are beafier than d16 one... got them for pretty cheap, TT rods are fine, but they cost 261 shipped to my house and customs is not include... so that would make 300$ for sure

b18 rods = 30$
machining done by a friend in his free time... let say 100$ max

that make a rod that is 170$ less expensive and they will still hold at 300hp
 

·
Registered
Joined
·
4,732 Posts
Customs? $225 shipped to door in USA.H beam 650hp.. where u gettin $300? but by all means i hear people using LS rods.. But I dont understand how people say b18a/b rods are weak over 275whp...but they are fine for 300whp in a d series?? just checking out !! no bashing or trash talking here.
 
1 - 9 of 9 Posts
Top