Honda D Series Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
364 Posts
Discussion Starter #1
I just wanted to make sure I'm doing everything right. I like to do things just once lol. Know, for my ring question...its about clocking them. If you were to look at the piston like a clock, the top ring would be at 8 o'clock. The second ring gap would be at 10 o'clock. The first oiling ring would be at 4 o'clock. The spacer gap would be right between 3 and 4. And the bottom oiling ring would be at 5. I'd put a picture up but I'm on my cell due to problems with my computer. Anyway, for the bearings, am I not supposed to touch the bearing face? I can see my finger prints on them. Can I just clean them? Thanks for the help in advance
 

·
Registered
Joined
·
527 Posts
piston clocking


as far as the bearings
clean them up with some alcohol and don't lube the underside of them just the top touching the crank journals
 

·
Registered
Joined
·
1,885 Posts
+1 for the above post.
-Luke
 
1 - 4 of 4 Posts
Top