[andresdelsol]

jrsc guys need your input here

in picture 1: which hose goes there?

in picture 2: what u guys think about the space between the pulley and the chassis? is itnt too close?

 

[andresdelsol]

Better get some stiff mounts! haha

thanks for the advise!

 

[andresdelsol]

Brake booster. I had the same amount of spacing. Just enough to slip the belt over.

thanks rep for you!

 

[andresdelsol]

You just need enough room to make sure you can change belts.

thanks bro

what he said. you're good man. just keep an eye on your driver side mount, if it goes you might be screwed.

edit: so what are the plans/specs for this warlock?

big plans, going sc + way too much nitrous

1. yeah the brake booster you know the hose that sitting right next to it in the pic????
2. thats close to the same spacing i have I have had no issues.

1. is ake booster as you know.

2 if you worryed about that take a hammer to it. push it in about 3-5mm.

trying to find a pic for you now. think i removed it from photobucket. might be on my home pc.

hammer? no dude the bearings can get damage by doing that.

I will post my setup for you tomorrow so you can see what hose is missing and where to, but I believe that a hose is missing to the intake.

please and thank you

 

[andresdelsol]

he meant hammer the frame not the pulley. if you moved the pulley then it wouldn't line up with the other pulleys.

thanks for helping

 

[andresdelsol]

this is so far what i have, i need to connect all the water houses, fuel houses and the electrical part on the tb
picture number 2 where the thise two houses goes to?
picture number 3 which house is going here?
picture number 4 from where is that house coming from?

 

[andresdelsol]

1 brake booster hose
2 no it wont rub mine didnt and thats how they all fit

i do know that is the brake booster but where it goes connected and in what order?

2 fuel line and vacuum line
3 water line from iacv
4 i cant tell but i think its the evap can or perg solonoid

can you please be more specific in number 2

What motor is this on?

Also what motor did the SC come from?

That happened when I put a y8 JRSC on my z6. I just hammered the frame a bit for peace of mind lol

d15b7 and it came from a d16y8

i cant see it moving from side to side much...it should be fine

thanks!

 

[andresdelsol]

I think this is why there is such little space.

Check to make sure the SC itself isnt touching the alt. When I put mine on the z6, it was touching the alt and grounding it so my car wouldnt start. I had to put something in between it lol

affortunatly is not.
thanks bro. can u post in here a picture of ur set up please. im a graphic learner
lol

 

[andresdelsol]

need some setups pictures guys!

 

[andresdelsol]

update: i ordered the braket for d15b7 engine cause the other1s woulnt fit. stupid braket cost me $276.

daved can you take a picture of the cooling houses of ur charger, im stock in that part too

 

[andresdelsol]

Cooling hoses??? Like the one on the passenger site that just loops back like a u turn??? Same as the stock mani??? Or the TB because I bypassed that years ago.

i was missing one hose but i got it already thanks.
only problem now is that i cant fit the braket so i took the alternator off to fit the bkraket, but the pully from the alternator doesnt let me fit the bracket.