[areskzc]

Well I swapped long ago my OEM steering wheel with blown Airbag for a JDMSir steering wheel,

Now the problem is that the usdm horn positive wire comes in the aribag module underdeath the steering wheel.

After removing it I notice that the steering has a metal plate that has a mark of sliding on some other metal part. My guess is that there is a jdm hub for these steering wheel but never had luck finding it.

Anyone has a clue how to wire this?

Thanx

 

[Levi]

are you talking about how to get the horn to work? If so, you can probably use some information out of this link to help you http://www.honda-tech.com/zerothread/1887852

 

[CrazyConscious]

are you talking about how to get the horn to work? If so, you can probably use some information out of this link to help you http://www.honda-tech.com/zerothread/1887852

Thank you so much for that write up!

 

[areskzc]

Thanx a lot
so a ghetto pen clip could do the magic hahha
I was going to use an electric brush for electric RC engines

 

[crazyxzer0]

I did it exactly the same way!


here is the official shoe horn part number from honda 88-91 civics.

35259-SH3-A02



now to put that 2ohm resistor in the harness to reset the srs light.