How much Psi on the Stock Greddy 19t?
1 - 6 of 6 Posts
Joined
·
4,732 Posts
im not sure. but im guessing it a stock kit...id say no more than 8psi. just a guess.
1 - 6 of 6 Posts
Join the discussion
Recommended Reading
-
JRSC Y8 Crank pulley vs stock
Forced InductionAnybody got a photo of the JRSC Y8 (3 RIB) Crank pulley or a photo of it next to a stocker? Was there ever a 4 rib crank pulley produced by Jackson Racing?- 152
- 14K
-
d-serious · updated
-
ECU tuning questions
Forced InductionHey guys! Im going to turbocharge my d16y7 soon and I was wondering about engine management, If i say id buy an P28 socketed and chipped ecu from H-tune. co . uk, Can i plug that ecu to my computer and connect it with Crome or whichever tuning software we use? Thanks!:online2long:- 13
- 915
-
Re programming after manifold swap?
Forced InductionHey guys i just bought a civic with a built d16 turbo engine with the common vitara setup, its been running fine but the manifold was cracked badly and blowed like hell also looked like a 10year old welded the manifold so the quality is s*it. im not a bad welder and considering making a new...- 55
- 2K
-
"The Greek D16 Turbo" build thread!!!
Forced InductionHi guys!!! Some of you probably seen my car before!!! So now its time to post my full built thread!!! After a long time,lots of money,stress and working ours i made the faster and most powerfull D16 for greek standards!!!LoL Down here they never tried to turbo a d16,so since i came back from...- 45
- 19K
-
DJSORTS · updated
-
effect of altitude on turbo selection
Forced InductionBeen working on a turbo setup for my crx for a few years, just put motor in, finally ready for the turbo. I was wondering on the effects of altitude on a turbo setup. I spend 1/2 my time in Denver, about 5000', and the other 1/2 up in Frisco, my driveway is at 9200'. Some of the mountain...- 18
- 4K
Join now to ask and comment!