Honda D Series Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
I've been building my D16A6 with JE pistons and Eagle Rods.
The problem is that the ARP bolts from the Eagle Rods hits the girdle.
I notched the girdle but by one bolt i can not take more material of because there is the oil line pipe.
So i want to ask if i can shave the bolt a little bit down without worries about the balancing???

Thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top