Honda D Series Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
Hi everyone ! huge problem..
i installed my new bearings put my pistons in attached h beam to the crank But the rods gets contact with my cylinder walls it dosent go all the way around.. whats the problem ??
the rods are made for D16

i have D16a6 Block.. Kind regards
 

·
El Noob
98 Civic EX/ 86 MR2
Joined
·
2,794 Posts
yes sir. Search for it. There has actually been like 2 people that have asked this recently. I will be doing it as well with my I-Beams. Which reminds me, I need to order my bits.
 

·
Registered
68 Camaro
Joined
·
4,583 Posts
there are threads for it, dont worry its nothing major as long as your carefull you shouldnt screw anything up
 

·
Friend of the D
Joined
·
3,069 Posts
1 - 11 of 11 Posts
Top