Honda D Series Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey everyone,

Done an engine swap in my EK3. D15Z6 engine to the D16Z6.

Have a P28 ecu wired in to run the engine, everything works however i have no Vtec!

The sensor (green plug) has 2 wires however the loom i have has 3 wires ?

Ive tried the combinations to wire the 3 wires into 2 wires however it just shorts something out and the engine wont start as soon as you attempt to wire it up ?

Anyone done this ? Please help lol !
 
1 - 2 of 2 Posts
Top