Honda D Series Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hey everyone i'm new to this forum. I recently did the auto to manual swap and it went fine until i ran into an issue on the first start. There was a loud grinding sound. So i took the trans out and saw this:
138873
138874

The pressure plate made contact with that bolt in the bell housing. no mjor damage done but its fustrated me with how this happened.

is my flywheel sticking out to much?
138875

I have a d16y8, the trans is b000 s40. and running a exedy fwhdc01 flywheel and exedy 08022. The pilot is sitting well as well. any help would be appreciated.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
well just learned today that it might be the interlock guide bolt sticking out too far; just enough to make a horrible sound. can anyone confirm? is it supposed to have a washer?
 
1 - 3 of 3 Posts
Top