Honda D Series Forum banner

1 - 5 of 5 Posts

·
Registered
2000 honda civic lx
Joined
·
14 Posts
Discussion Starter #1
Hello all,
Own a 2000 civic 4 door auto. Planned on this giant I series swap etc but when I realized I make less then acceptable $$ in thr state of CA I changed up my thinking...
So yesterday I found a d1z6 head with 5 speed transmission for 120$...of course I bought it...now I'm about 80% mechanically inclined (army called me one for four years) so anyways now I'm wondering what little tips etc you all have for this head obviously have it cleaned resurfaced etc...was also planning on swapping intake manifold first until I get a break from work..as fkr the 5 speed transmission.ill clean it but parts but have a shop install it....here are some pictures let me know what you think
YES I know vtec needs to be wired etc
Recommendations on ECU? Also how will it work with y7 block . I plan on replacing piston rings etc nothing too crazy...anyone have experience?
 

Attachments

·
Registered
Joined
·
5,878 Posts
Work on completing sentences first, your post is very hard to follow.

little drunk early for new years? lol, no harm, no foul
 

·
Registered
2000 honda civic lx
Joined
·
14 Posts
Discussion Starter #3
Work on completing sentences first, your post is very hard to follow.

little drunk early for new years? lol, no harm, no foul

you got me. ha ha no I'm actually at work at 1800 radiator and had to sneak in that post before another call came in..
 

·
Registered
Joined
·
88 Posts
I ran a p28 with neptune on it for my 99 coupe. Going to use the same set up for my 99 sedan as well.
 

·
Banned
my size 9.5 pumas
Joined
·
3 Posts
Hello all,
Own a 2000 civic 4 door auto. Planned on this giant I series swap etc but when I realized I make less then acceptable $$ in thr state of CA I changed up my thinking...
So yesterday I found a d1z6 head with 5 speed transmission for 120$...of course I bought it...now I'm about 80% mechanically inclined (army called me one for four years) so anyways now I'm wondering what little tips etc you all have for this head obviously have it cleaned resurfaced etc...was also planning on swapping intake manifold first until I get a break from work..as fkr the 5 speed transmission.ill clean it but parts but have a shop install it....here are some pictures let me know what you think
YES I know vtec needs to be wired etc
Recommendations on ECU? Also how will it work with y7 block . I plan on replacing piston rings etc nothing too crazy...anyone have experience?
p28 ecu take the oil port plug out on the deck of the block and wire it also use the search it works good luck and happy new years
 
1 - 5 of 5 Posts
Top