[civik]

Hey everyone. I've searched for this and can't get a straight answer.
If i put Z6 head and intake mani in a Ek cx(D16y7) will the Cold air intake from my Eg(d16z6) fit?
Sorry if this is obvious. I've just bought the 99 hatch and don't know much about Ek's and eg compatibility. If anyone has any info on anything regarding eg to ek compatible parts that would also help.

cheers

 

[areskzc]

Hey everyone. I've searched for this and can't get a straight answer.
If i put Z6 head and intake mani in a Ek cx(D16y7) will the Cold air intake from my Eg(d16z6) fit?
Sorry if this is obvious. I've just bought the 99 hatch and don't know much about Ek's and eg compatibility. If anyone has any info on anything regarding eg to ek compatible parts that would also help.

cheers

Possible yes. but if you have the parts why don't you just test the fit?

 

[civik]

Will do when i can. I've just bought my ek hatch and am noticing the similarities and differences. It seems the ek mounts push the engine forward and to the left a little bit in comparison to my eg. There is also no hole in the chassis where the cai would poke out into the bumper. I thinks i can just cut myself a passage. i dont know though. i am a noob after all. Just looking for some input. I'm very excited to get my nails into the ek and see just what can be done. plan on obd1, y7 to z6 minime and perhaps d15b pistons. this will be of course an ongoing project. I have learned lots seaching the "d" and it's all going to good use. thanks to everyone.

can i rep everybody all at once? jk

 

[wizard's blood]

im sure it will. the ek has the most forgiving bay. i hope u have ur wheel wells thought

 

[civik]

im sure it will. the ek has the most forgiving bay. i hope u have ur wheel wells thought

What do you mean? WHeel wells? so i don't get hydro lock?

Does anyone know if i can cut a hol through the chassis for the cai? even if the hole is a little different than the outline on th chassis