DIY Ek Civic(96-00) Led Cluster and Climate control conversion
61 - 68 of 68 Posts
Joined
·
3 Posts
Not at this time, but give me about a week to do the Cluster and i will post one up. :yes:
~D
Hi I don't know if this going to sound weird but on my Civic 96, instead of a clock there is a weird meter there. Is there any way I can change it either to a clock or an empty slot so I can put my phone or wallet there? Its my first car and I don't really know much about it.
Joined
·
2,796 Posts
^^^
Take a pic and lets see what it is
Take a pic and lets see what it is
Joined
·
1 Posts
Hey can anyone tell me if these would work for the dimister/hazard and also the t5 and t10 inputs in the cluster??
NEOx LED Bulb - High Power Instrument Panel LED | Instrument Cluster & Gauge LED Lights | LED Car Bulbs | Super Bright LEDs
NEOx LED Bulb - High Power Instrument Panel LED | Instrument Cluster & Gauge LED Lights | LED Car Bulbs | Super Bright LEDs
hey great details and it looks awesome.. question .. those 2 t5 lights on top of the cluster which made the needle glow.. is that only on the EK models?? .. i have a USA 98 honda civic ex MT .. and im going to do the same but im dont think i have those 2 lights above the cluster, and if not, can they be added?
61 - 68 of 68 Posts
Join the discussion
Recommended Reading
-
F.Y.I. Avoiding EF Clutch Pedal Assembly failure
DIY Forum1988-1991 Crx's and civics have a weak point on the clutch pedal. They are prone to cracking at the welds, usually as the vehicle gets higher miles or with a heavier duty race clutch. The bolt that the clutch pedal pivots on is welded to the pedal assembly; the welds are the weak point. It's...- 4
- 8K
-
Robb · updated
-
How to restore ef9 tail lights
DIY ForumFirst cleaned the whole light. Then buff the lens out. Turtle wax Scratch Out works great and is priced right. Then heat the oven to 170 degrees Set it on a big pizza pan. Just don't set it on the rack. I set the timer for 15 minutes. Now it's kinda warm and ya got about 3 or 4 minutes to...- 1
- 240
-
Honda Mike · updated
-
DC/EK power steering delete - killing the slop (write-up)
DIY ForumA lot of people have done a P/S delete for various reasons. If you simply loop the fluid lines you will have some slop in the steering wheel which may cause a low-speed clunk over bumps. This will fix that and feel as tight as a rebuilt manual rack, but with a lower ratio. The main reason for...- 1
- 499
-
HiProfile · updated
-
P28 vtec conversion
DIY ForumHey guys I have a couple questions for this same conversion. I am installing a P28 with automatic tranny, do I pin the lock up solenoid straight to the ECU? Does the distributor wire have to shielded, like a ground the wires? Do I remove the green plug, because from the original set up some...- 0
- 283
-
Civicpeg · updated
-
How to fix Honda idle.
DIY ForumI run across this SO often I am just going to make a DIY article. Honda ECUs hate to idle fast, they do some crazy stuff to try to get the idle within the correct range, and it can cause serious driveability issues and CELs and just make the car VERY annoying. Just remember, the car doesnt...- 21
- 6K
-
JoelEspinoza · updated
Join now to ask and comment!