Honda D Series Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter #1
Is there any way to install a Demon 2 board in a Ecu that's chipped for Hondata. *I see that the pins are a little different. *Didn't know if there was a way to make it work
 

·
Classic Man
Civic
Joined
·
16,355 Posts
When we have to do it at work, it involves desoldering the old pins or bed and putting the opposite either male or female terminals depending on which way you are converting. It sucks!

I had to do it recently on my own ECU and I had some issues afterwards where I had to go back and reflow some solder joints before the S300 would work correctly. And i chip ECUs all the time at work so I have some experience and even then its not easy.
 
1 - 4 of 4 Posts
Top