[roberts]

Hi everyone!

I know this has been discussed al lot,but didn'd find answer about rods for setup I am planning to use.

* d15z1 block with stock rods
* d16z6 head with stock cam
* pistons??? p28 or p29

I know p28 pistons can be used. It will turn out just like z6 block?
SO basically my question would be -> Will p29 high compression pistons fit this setup?

 

[Dweezil]

Nope, P28 or any other 1.6 rod won't fit the crank. For pistons you can use `01 GX pistons if your trying to raise compression. 10.79:1 useing the Z1 block and Z6 head. Kind of a poorman's D15B VTEC.

 

[roberts]

WOW I am realy sorry,I just notices I messed up and intead of "pistons" wrote "rods". :hammer: :liar:

So what I want to know is "WILL P29 PISTONS FIT THIS SETUP"?

 

[Dweezil]

They sit above the deck slightly. Look for Bone'd baby8 build for more info.

 

[labatt2k]

get pms piston...

 

[roberts]

Ok,just got through bone thread. Got more questions to be answered now. :newbie:

Also BONE uses d15b7 head with ported chambers. I will use d16z6 head. There should be difference.

What I am looking for =
* d15z1 block with P29 pistons
* d16z6 head (not milled) with z6 head gasket
* have laying around zex59300 cam and stock z6 cam

So my questins now are =
1) all d15 blocks and cranks are the same? (excepting rods and pistons)
2) As pistons probably will stick out of block a bit,should I worry about valve to piston clearances if I am using z6 head?!
3) what compression could be with this setup?

I hope for some help! :TU:

 

[Dweezil]

15.3:1, but I'm sure things will hit.