Honda D Series Forum banner

D16y8 cuts in and out

2K views 4 replies 3 participants last post by  95coupeD16y8 
#1 ·
Hello I drive a 95 civic ex with a stock d16y8 engine and the p28 ecu is chipped. My engine cuts in and out if i press the gas pedal to the floor when I'm at 4500 rpm. I'm not sure if this is a fuel or tuning issue. Only mods the car has is a 3 inch exhaust from the header back, aftermarket header, and a short ram intake so nothing major has been done. Any suggestions of what would cause the car to kind of studder around when flooring it from any gear at 4500+rpm?
 
#4 ·
Yes my car is stock, just engine swapped. The d16y8 is completely stock from a 2000 civic ex. Yes i know my car should have a z6, but it doesnt. I'm assuming previous engine was blown because of oil in the radiator. But anyway, back to the issue at hand.
What is tps?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top