Honda D Series Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
103 Posts
Discussion Starter #1
my d16y7 has a rod knock. i have a d16y5 shortblock laying in my garage with low miles. will the d16y5 block fit with no problems? is there anything to change when putting on the non vtec head? ...this is my daily i just want to get it running good again not looking for performance.. thanks
 

·
Registered
Joined
·
7 Posts
I know your always suppose to use the timing belt hg and head bolts that are for the head...what year is y5 out of does it have a crank sensor?
 

·
Registered
ej8
Joined
·
6,367 Posts
I know your always suppose to use the timing belt hg and head bolts that are for the head...what year is y5 out of does it have a crank sensor?
Y5 is obd2 vtec e motor. So it will be 96-00
And i remeber the same you use everything for the head.
I believe its a simple swap. Y7 hg and you can use everythong else from the y5 since the.blocks should be the same just different pistons since its a y motor.
 
1 - 4 of 4 Posts
Top