Honda D Series Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Just wanna know what you guys think about the setup that I am running. Also estimated about of hp im pushing.

89 d16a6 1.6 single cam non v-tec balanced crank and rods stock pistons and rings,shaved head,5 angle valve job,ported intake man,tb bullfrog butterfly,bullfrog stage 2 cam si ecu chipped rev limit at 7000rpm motor pulls damn hard AEM short ram intake 1st gen b16 injectors. Running a 88 zc tranny with a stage 3 clutch had to put it in only clutch I dould get my hands on.
 

·
Registered
Joined
·
3,586 Posts
I'm going to guess around 120 or so with stock compression.
 

·
Registered
Joined
·
1,737 Posts
msd, zc pistons or just turbo haha
 

·
Registered
Joined
·
259 Posts
y is your si ecu chipped for a 7k rev limit....or did you mean to put a comma and say that its chipped, then at 7k it pulls hard? Just wondering

ALso how much is your head shaved?
 

·
Registered
Joined
·
8 Posts
jayz_si whats up man. hey just wanted to ASK u how much have u spend on the motor. is tuned. only reason im asking is cause i have the same motor and i am planining on building it. what cam r u running. do u have stock valves
 
1 - 10 of 10 Posts
Top