Honda D Series Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I recently rebuilt my d15b because i spun a bearing, and after like 6 months of going places and measuring i finally figured out that the main and connecting rod journals are the exact same size so....when buying main bearings here for it, you will need to buy regular d15b(2,7) bearings. But when buying the connecting rod bearings you will need to buy them for a d16a6.

My motor runs strong again besides the fact that my temp gauge always is below cold but when i let my car run for a while it will start to make its way in between hot and cold, but once i start driving it goes back below cold. Any solutions???
 
1 - 3 of 3 Posts
Top