Honda D Series Forum banner

1 - 3 of 3 Posts

·
Registered
1997 Honda Ballade
Joined
·
580 Posts
Discussion Starter #1 (Edited)
So I got some Pm7 pistons I want to put in my D15B but I was unsure of the valve clearance. So I put them in my D15B3 engine to test.

I suppose I could have posted or searched on this forum but that would have been noobish.

First hand experience is way better.





push fitted the gudgeon pins myself.








All clear.

I am going to buy a head gasket/ big end bearing and main bearing and some rings.
And then install them in my D15B
 

·
Brokedick Millionaire
Joined
·
40,237 Posts
waste of time and money for .2 bump in compression.

Shaving the head .020"/.5mm would have yielded better results.

You now have a 9.5:1 motor......
 

·
Registered
1997 Honda Ballade
Joined
·
580 Posts
Discussion Starter #3
waste of time and money for .2 bump in compression.

Shaving the head .020"/.5mm would have yielded better results.

You now have a 9.5:1 motor......
Already done.

just not the head in the pic. that was just for testing.
 
1 - 3 of 3 Posts
Top