Honda D Series Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
Im freshen up my engine a d16z6 new seals etc. the I have couple of d16z6 crank pulley and this one is rusted. I also have another D15 crank pulley that seems smaller than the original d16s. I have a engine that don't need power steering etc. a/c
also lighter?

im thinking did anybody use a d15 crank pulley on a d16z6?

need to get this motor back on the road.
anyone did this?
 

·
Registered
Joined
·
8 Posts
I did this on my z6 for a while, felt like i gained some power from it too. Only thing is i was worried it would be hard on the bearings because the d15 doesnt have a harmonic damper built in, so i ended up swapping back.
 

·
Brokedick Millionaire
Joined
·
40,267 Posts
I did this on my z6 for a while, felt like i gained some power from it too. Only thing is i was worried it would be hard on the bearings because the d15 doesnt have a harmonic damper built in, so i ended up swapping back.
ruined main bearings in 500 miles using a D15B7 crank pulley on a stock D16Z6....that was 1999?
 
1 - 3 of 3 Posts
Top