Honda D Series Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
223 Posts
Discussion Starter #1 (Edited)
planning a low boost 6-7psi set up on my d15b mini me, but i want to put a lil insurance in the bottom end, im thinkin stock d15 pistons, a good set of piston rings, main/rod bearings. but i dont want to do the d15 connecting rod thing so i was wounding about shot peening my stock ones. what do YOU think? strong enough? no chrio too much $$.
 
D

·
Guest
Joined
·
0 Posts
could shot peened d15 rods handle a 50 shot? how about a 65 with SRP 10.6:1's?
 

·
Registered
Joined
·
1,453 Posts
guest said:
Jeff on HMT boosted 12psi on a b2....... I think it was a mini-me to (don't quote me on that though).
cool id do that but i need 3bar map still, but im always afraid that if i throw a rod metel chucks will go into my turbo oil feed and screw up my turbo bearing
 
1 - 10 of 10 Posts
Top