Honda D Series Forum banner

1 - 2 of 2 Posts

·
Registered
crx
Joined
·
2,683 Posts
Discussion Starter #1
i am going to put a z6 head on the A6 in my crx and i was wondering what my tunign options are whiel im still running a chipped OBD-0 ecu. from the search i came across a few ran a PG7 map wich is the 89 integra ECU. i know a lot of peopel are goign to say to go to OBD-1 but im doing that later on when i come back from vacation. i just want to run it with a chipped OBD-0 temprarily. what woudl be a good redline and stock scrossover point for the stock Z6 cam. i was also wonderign if anyoen tried those low buck vtec controllers they are selling on ebay? looks like a nice little gadget to run till i do the full OBD1 swap.
 

·
()*#$(*$
93 Legend L Coupe.
Joined
·
11,404 Posts
OBD-1 swaps are ghey for a majority of simple setups. You can easily mod the ECU to run VTEC if it isn't so equiped with an AC output, or programed to control other outputs to switch on VTEC. TE is coming along and will progress and might even end up better than popular OBD1 tuning software. I refuse to abandon it yet. LOL!

A good redline is ~7-7400 depending or when it really starts falling off. Cross it over ~4500.
 
1 - 2 of 2 Posts
Top