Honda D Series Forum banner

1 - 5 of 5 Posts

·
Registered
SCCA F Prod CRX Si
Joined
·
70 Posts
Might be easier with a pull type slave cylinder. Then it would mount from above.

But, start adding metal till it mounts to the trans and is stiff enough to work.
 

·
\/Your Mom Was Here\/
Vibe GT
Joined
·
4,833 Posts
I stumbled across someone that did this, but IDK how you would bleed it





Or get the Hasport kit

It's a B-series though... But you should be able to use the push rod setup. Maybe not buy the kit but make one.
http://hasport.com/store/tech/egbcc.pdf
 

·
Registered
97 honda coupe
Joined
·
7,611 Posts
i wouldnt even mess with that cylinder setup your talking about doing. hydro trannys are easy enough to find it would make everything 100% easier and less painfull. YOu have to make sure you get your leverage points correct or else you might not fully release the clutch.

I did a cable to hydro conversion on my crx, the thread should be on here somewhere.
 
1 - 5 of 5 Posts
Top